“SquishServer无法注册Windows防火墙”

最后编辑了

启用Windows防火墙

When the Windows firewall is enabled the Squish IDE Runner/Server Log view might show an entry like the ones below:

squishserver: Failed to register with Windows firewall

Failed to verify that process was registered in firewall; might cause connection problems

这应该只在Windows Vista和更高版本上发生,并且当啜饮时没有使用高/完全管理员权限运行(因为不允许该过程与防火墙一起注册;可能是因为 UAC.)。

此消息只是为了您的通知,因此您不会忘记允许SquishServer访问和绕过防火墙,或将其添加到允许自己绕过防火墙的应用程序列表。

使用已禁用的Windows防火墙

When the Windows firewall is disabled the Squish IDE Runner/Server Log view might show entries like these:

CoCreateInstance failed: 0x800706d9
WindowsFirewallInitialize failed: 0x800706d9
squishserver: Failed to register with Windows firewall

These messages only report failure to handle or configure the Windows Firewall, and should not in themselves have any adverse affect on Squish or the squishserver.

However, if the Windows firewall has been disabled or shut down, this normally means that a third-party firewall has been installed in its place. A third-party firewall might affect the network-based communications of the Squish components (e.g., squishrunner and squishserver)。